(TP3521E)PCA® - EasyEmboss Outline or Cutout Frames 2

PCA® - TP3521E EasyEmboss Outline or Cutout Frames 2 Template. A frame design which can be embossed as shown or if desired, may be cut out to give a silhouette effect. Emboss as normal using your PCA Micro Ball Tool. Once complete, re-trace the selected areas using your PCA E3001 Scriber tool. (while paper is still on template).  When using Scriber tool on intricate areas, it may be necessary to go over your work a couple of times until the paper has cut all the way through. If you have any rough edges after finishing, place vellum on perforating or embossing mat. Then using a Small Ball tool, re-trace the inside of the cutout, with the side of the tool shaft rubbing along the cut edge. This will easily smooth out any rough bits should they occur. Simply by moving paper on template during intial embossing you can create any size frame required. Remember, if choosing to cut out frame holes, turn paper over for any further embossing, and reverse paper again for any perforation.  Mix and match with other PCA templates / inserts. Very easy with excellent results. Add your own perforating, colouring and wording. As always we suggest that you rub the vellum with a piece of tumble dryer sheet or similar to improve slip when embossing. Place vellum on top of template. Hold vellum in position with small pieces of 'Blu-Tack' or similar.